Argox OS-214ZIP Dokumentacja Pobierz pdf (Strona 41)

Parallel (Centronics)

The parallel port is a standard 36-pin Centronics. Pin

assignments are as follows:

Direction

Definition Pin Direction

Definition

In /STROBE

Out SELECT

In Data1

14,15

In Data 2

- Ground

In Data3

- Ground

In Data4

18NC

In Data5

19~30

- Ground

In Data6

In Data7

Out /Fault

In Data8

33~36

- NC

Out /ACK

11t

Out BUSY

Out PE

Auto Polling

Both the serial port and parallel port of this printer can be

activated at the same time, i.e the printer can simultaneously

communicate with two PCs via different ports. However as no port

contention is made for this printer, if both PCs transmit data at the

same time the data may become damaged in the receiving buffer.

Appendix I - Installing Dispenser Kit

1. Turn off the printer power and unplug the printer.

2. Unwrap the dispenser kit and take out screws, the shaft,

the plastic roller, the dispenser bar, the direction label, and

the peeler sensor cable.

Top Cover

3. Take off the top cover of the printer.

4. The peeler sensor cable has a sensor board at one end

and a connector at the other end.

5. Mount the two little holes of the sensor board on the two

spines at left upper corner inside the top cover, keeping

the cable at the left.

6. Route the peeler sensor cable through the guides along

the left side of the top cover.

7. Fix the sensor cable and sensor board with Loctite-444

instant adhesive or equivalent.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46

Komentarze do niniejszej Instrukcji

Brak uwag

Argox OS-214ZIP Dokumentacja Strona 41

Komentarze do niniejszej Instrukcji